The deformation of a sign with bent areas not only impairs its aesthetic appeal and renders it visually unattractive but also poses difficulties during the installation process. Consequently, it is imperative to promptly address this issue upon its discovery. Our expertise at Trilogift lies in the restoration of bent signs to their original flat shape, making us well-equipped to provide comprehensive guidance on the most effective techniques to achieve a perfectly flat and visually appealing sign.
In this guide, we’ll cover two methods:
Using Hands to flatten the Metal Sign
In general, the curved areas of the sign are typically located within the patterned sections, so the link at these points is usually not too hard. Hence, the most straightforward approach entails manually bending these areas using one's hands. Please ensure meticulous adherence to the following steps:
Step 1: Assess the overall condition of the warped metal sign.
Step 2: Bend gently and even pressure with your hands on the warped area of the sign. Gradually and patiently bend it back into shape, while carefully monitoring the bending process to avoid causing further damage.
Step 3: Check the sign after each bending attempt to see if the warping has sufficiently flattened. If necessary, continue bending until the sign becomes flat.
Using a Rubber Hammer or a Cloth-Wrapped Iron Hammer
In the event that the manual bending of the sign by hand does not result in complete flatness, an alternative and effective method entails the use of either a rubber hammer or a cloth-wrapped iron hammer. Please proceed by carefully following the subsequent steps provided below.
Step 1: Prepare a flat wooden surface or any other sturdy flat surface.
Step 2: Place the warped sign on the flat wooden surface.
Step 3: Use a rubber hammer or a cloth-wrapped iron hammer (to prevent damage to the sign's surface) and lightly tap on the warped area of the sign. Tap gently and patiently to avoid causing further damage to the sign.
Step 4: Continue tapping on different areas of warping on the sign. The warping will gradually flatten during this process.
Step 5: Thoroughly inspect the sign after each tapping session to determine if the warping has significantly reduced. If needed, repeat the above steps until the sign becomes flat.
To achieve the flattening of the Metal Sign using these two specific methods, it is advisable to carefully follow the instructions presented in the accompanying video
We hope that these two methods will assist you in effortlessly and effectively repairing a warped metal sign. However, if you encounter any challenges or require additional guidance, please do not hesitate to reach out to us for further assistance.
